Mayline Pedestal Table TP72 Manual do Utilizador descarregar pdf

Kwik-File, LLC

PEDESTAL TABLE

TP48, TP60, TP72

ASSEMBLY INSTRUCTIONS

1.With table upside down install table legs as per table

installation instructions.

Note: Pedestal may be installed on either left or right

side.

2. Remove drawers from pedestal. Extend drawers

and release the catch on each side of the drawers.

Pull drawers off the slides and push slides back into

the pedestal.

3. Mount rear Z-shaped bracket to top and align

mounting holes with 2 pre-drilled holes under table

top. Secure using two 3/4" long screws provided; use

a 3/8" socket. Install two 1/2" long screws as shown

into the 1/4-20 inserts in rear Z-bracket. DO NOT

TIGHTEN. Leave about a 1/4" gap between bracket

and screw head.

4. Attach front mounting bracket using four 3/4" long

screws and align mounting holes with the four

pre-drilled holes in the table top. Leave these screws

loose for now.

5. To mount pedestal, lift it so lip (in front of hole in top

of pedestal) rests inside the groove in the front

mounting bracket. Align rear keyholes in the top of the

pedestal with the 1/2" long screws (partially secured to

the rear Z-bracket). Pull pedestal forward so the

keyholes engage with the screw heads. Position the

pedestal flush with front of the table frame. Tighten

screws in front and rear brackets.

6. Flip table up on its legs.

7. Replace drawers in pedestal by extending slides

and reversing step #2. Be sure drawers slide in

completely, then lock in catches.

1/2" Screw

3/4" Screw

Kwik-File, LLCPEDESTAL TABLE TP48, TP60, TP72ASSEMBLY INSTRUCTIONS1.With table upside down install table legs as per table installation instructio

Sem comentários

Mayline Pedestal Table TP72 Manual do Utilizador